Home > VerMeister >

VerMeister EZY 2 Component Finish - High Performance - Superior Flow
Vermeister Ezy


Vermeister Ezy

It has never been so easy to finish a wood floor and achieve an excellent final look. Ezy, the first infallible finish for wood floors even under extreme conditions.
Two component polyurethane double cross-linking finish with DCS Dual Curing System Technology to achieve excellent performance in terms of resistance to wear, as well as greater
ease of mixing and use. The 2 components can be mixed simply by adding component B to the container of component A and shaking without the need for any particular mixing procedures.

Available in 10, 30 and 60 gloss, it maintains the natural look of the wood thanks to its high level of transparency, guaranteeing excellent coverage and filling, even when only two coats are applied.

The superb flow of the film, even when applied thickly, complete the characteristics of a product which is unique in the industry. EZY can be used directly on the wood, even as a single
component first coat when faster cycles are required, so just one single product in used for greater convenience. It guarantees an excellent final look even under the most extreme
environmental conditions.

Technical data sheet

Item# Item Name List Price Price Qty Add
VM-506375-10Gloss VerMeister EZY 2 Component Finish - HP - SF - Matte
VM-506375-30Gloss VerMeister EZY 2 Component Finish - HP - SF - Satin
VM-506375-60Gloss VerMeister EZY 2 Component Finish - HP - SF - Semi
Check the items you wish to purchase, then click

  • Choose the easiest way !!

More Information:
  • Labeled "The most forgiving and easiest to use finish" by contractors Excellent flow and leveling Outstanding scratch and chemical resistance Non-yellowing Lowest Matte sheen available on the market


FAST CYCLE: apply a first coat of single component EZY directly on the wood and after about 3/5 hours, sand with a fine abrasive screen (180/220 grit). Mix component A with component B of EZY, in the amounts stated, simply shake the contents inside the container, then apply a uniform second coat.

TRADITIONAL CYCLE: before application, the surface must be treated with a water based primer or a Vermeister two-component solvent based primer.

In the latter case, it is necessary to bear in mind that those species of wood subject to strong oxidization (doussiè, iroko, etc.) acquire a very dark color when they are coated with solvent based primers.

For this reason, the barrier created by the polyurethane primer must be continuous and uniform over the whole surface in order to prevent the formation, over time, of unpleasant lighter colored stains. Care must be taken not to break through the layer of primer when sanding.

Mix component A with component B, in the prescribed proportions, even by simply shaking them in the container.

Apply EZY evenly. Usually at this point the coating is complete. If another coat needs to be applied, it can be done after 2-5 hours without sanding. If overcoating is performed more than 5 hours later, the surface must be sanded before applying the finish to prevent separation from occurring.

Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

VerMeister > Finishes