Home > VerMeister >

VerMeister Idro 2k Two Component Finish - High Performance
VerMeister Idro 2k


 
Vermeister Idro 2K is a two-component polyurethane NMP-free waterborne non-yellowing finish available in matte finish (10 gloss), satin finish (30 gloss), and semi finish (50 gloss). Floors treated with this finish acquire a natural appearance, uniformity and a cleanliness equal only to the results achieved with oil and wax impregnation cycles. Apart from these characteristics regarding the finish look, Idro 2k also combines qualities of resistance to abrasion and to scuff marks that have never before been provided by waterborne products, so much so that the product is even recommened for "heavy duty" or commercial flooring such as showrooms, shops, etc. Labeled by customers as one of the most user friendly.

Technical Data Sheet


Item# Item Name Price Qty Add
VM-506326-10GLOSS VerMeister Idro 2k - Matte - 10 Gloss
$105.00
VM-506326-30GLOSS VerMeister Idro 2k SAT - Satin - 30 Gloss
$105.00
VM-506326-50GLOSS VerMeister Idro 2K EXPORT - Semi - 50 Gloss
$105.00
Check the items you wish to purchase, then click


:




More Information:
  • Labeled "The most forgiving and easiest to use finish" by contractors Excellent flow and leveling Outstanding scratch and chemical resistance Non-yellowing Lowest Matte sheen available on the market




Instructions:
APPLICATION
Before proceeding with the application, the surface must be treated with a Vermeister waterborne
sealer or solvent based two component primer. In the latter case, it must be remembered that species
of wood subject to strong oxidation (doussiè, iroko, etc.) acquire very dark shades when they are treated
with solvent based finishes. For this reason, the barrier created by the polyurethane primer must be
continuous and uniform over the whole surface area to prevent the formation over time of unpleasant
darker patches. Consequently, it is important to take care not to “wear through” the layer of primer
when sanding. Mix component A with component B, in the prescribed proportions, stirring continuously
to prevent the formation of skin or lumps. If these impurities should be noticed, it is advisable to filter
the product before use. Apply IDRO 2K in a uniform way. Usually at this point, the finish is complete.
If it should be necessary to apply another coat, it can be done after 3-5 hours without sanding. If the
interval before overcoating should be longer than 5 hours, the floor must be sanded before applying
the finish to prevent separation from occurring. Alternatively, IDRO 2K can be applied directly on the
wood instead of the sealer. Use of IDRO 2K is not recommended on solvent based semi-gloss/matt
polyurethane moisture-cure finishes due to the risk of flaking in the case of insufficient sanding. To
facilitate the application of the product, it can be diluted with 5 – 10% of SOLUZIONE after the two
components have been mixed together. If the product is diluted any more than the quantities stated
above, coverage may be reduced with a consequent lack of uniformity in the finished appearance.



Share your knowledge of this product. Be the first to write a review »

Browse for more products in the same category as this item:

VerMeister
VerMeister > Finishes
Finishes